Pooling Health = Invalid Partials/Valid Partials

[GEARHEAD]

Hello everyone!
So I’m just getting back into Chia again and I have been on about a month already.
I’m getting high invalid partials on SPACEPOOL. Anyone know what could cause this.
Image below shows info. I am using a GPU for Plotting/Harvesting
P.S. I note that I’m seeing stuff in the logs, a lot of banning ip’s etc. If anyone needs that I can post it.

This is my setup

1. Windows 10 pro
2. Chia GUI 2.1.4
3. BladeBit Plotter (Cuda Plot) 3.1.0
4. GPU: A4000
5. Mobo: Gigabyte z590 Elite AX
6. i9-10900F 10th GEN 2.80GHz
7. Ram: 128GB
   
   

[ksevin]

1.3 % is not high. But you can check this post to optimize your config.yaml.
I got very helpful info from this post.

Health Check your Farm - Tips... e.g. Missing Signage Points, Invalid Partials, ASIC Timelords

Missing Signage Points Missing signage points can occur for several reasons, including network issues, time synchronization problems, or issues with your Chia node. Here’s how to address them: Network Stability: Ensure your internet connection is stable and your DNS settings. Tip: A wired connection is more reliable than Wi-Fi. Also set Port forwarding to 8444 on the router assigned to your computer IP and turn off upnp on your router. Also Benchmark you DNS from your location e.g. GRC’s DNS…

[GEARHEAD]

Thank you. I will check it out and see if anything is helpful.